Philips DCC951: Difference between revisions
m →specs |
|||
| Line 1: | Line 1: | ||
=specs= | =specs= | ||
* snaren: | * snaren: | ||
** capstansnaar lengte dubbelgevouwen is ongeveer 150 mm, of iets korter. | |||
** ladesnaar lengte dubbelgevouwen 98mm, vierkant 1,3mm breed. | |||
* aandrukrol: 13 x 6 mm as: 2 mm | * aandrukrol: 13 x 6 mm as: 2 mm | ||
??Verder moet je de voeding nakijken, soldeerverbindingen van o.a. de spanningsregelaars. | ??Verder moet je de voeding nakijken, soldeerverbindingen van o.a. de spanningsregelaars. | ||
Revision as of 19:41, 20 November 2018
specs
- snaren:
- capstansnaar lengte dubbelgevouwen is ongeveer 150 mm, of iets korter.
- ladesnaar lengte dubbelgevouwen 98mm, vierkant 1,3mm breed.
- aandrukrol: 13 x 6 mm as: 2 mm
??Verder moet je de voeding nakijken, soldeerverbindingen van o.a. de spanningsregelaars.
initialize a tape
Initialize new tapes, or make them new again: For DCC730 & 951: REWIND, REC SELECT/PAUSE
clead head is displayed
'Clean Head' is displayed when
- 8 hrs of ACC is played
- 2 channels or more on DCC tape not detected by DCC head for more than 3 seconds.
In case CLEAN HEAD indication was caused by a temporary bad head-tape contact, the message will disappear after pressing TIME or TEXT key.
track numbering
According to the DCC specification, on side B a new track number starts.
So, when recording from CD, and a track overflows from side A, a new tracknumber will be generated at the start of side B.
Therefor, all tracknumber on side B will be the original numbering +1