From www.ReeltoReel.nl Wiki
Jump to navigation
Jump to search
| Specifications
|
Tape Transport
| Track Configuration
|
1/4" (6.3 mm) Width Tape, 2-track 2-channel, NAB or DIN Stereo
|
| Nom. Tape Speed
|
38.1 & 19.05 cm/s (15 & 7.5 ips) switchableChangeable to 19.05 & 9.5 cm/s (7.5 & 3.75 ips)
|
| Speed Accuracy
|
Within ±0.2%
|
| Speed Deviation
|
Less than 0.2%
|
| Pitch Control
|
±20% continuously variable control.Percentage or ips readout with 0.01% precision multiturn encoder servo system.
|
| Fast Wind Time
|
60 Hz = 100 s, 50 Hz = 110 s (2,500 ft tape)
|
| Reel Size
|
NAB 10.5", 7", 5", EIA (cine), DIN ReelTape Max. Length = 3,280 ft (tape thickness 50 μm)
|
| Motor
|
Capstan = DC Brushless Motor, Quartz PLL Controlled Direct DriveReel = AC Induction Motor
|
| Head
|
Plug in head block with full access to independent head height, tilt and azimuth adjustment
|
| Start Time(Time to reach within twice specified wow & flutter.)
|
38.1 cm/s = Less than 0.5 s19.05 cm/s = Less than 0.3 s9.5 cm/s = Less than 0.2 s
|
| Wow & Flutter(PEAK WTD, DIN45507, IEC Pub.386)
|
38.1 cm/s = Less than ±0.06%19.05 cm/s = Less than ±0.08%9.5 cm/s = Less than ±0.12%
|
| Tape Timer
|
Seven segment LED readout from tachometer/logic measurement circuit; indicates tape time in Hours, Minutes and Seconds.
|
| External Speed Control Range
|
-50%, +100% at all speeds (4.8 to 19.2 kHz)
|
| VEM Tape Speed
|
+100% with VEM optional accessory and continuous lower speed change accompanying tone change
|
|
|
|
Electronics (Measured with AMPEX #456 tape. 0 dBu = 0.775 V)
| Line Input
|
3-pin XL Type Connector (female)Transformerless Active BalancedInput Impedance: 10 kΩRef. Input Level: +4 dBu (0 to +10 dBu), -16 dBu (-10 to -20 dBu)Max. Input Level: +30 dBu
|
| Mic Input
|
3-pin XL Type Connector (female)Transformerless Active BalancedInput Impedance: 10 kΩ (20 Hz to 20 kHz)Min. Input Level: -70 dBuMicrophone Impedance: 150 to 10 kΩWith Supply Channel (CH1/BOTH/CH2) Selection Switch
|
| Line Output
|
3-pin XL Type Connector (female)Transformerless Active Balanced (bal/unbal. switchable)Output Impedance: 5ΩRef. Output Level: +4 dBu (0 to +13 dBu), -16 dBu (-7 to -20 dBu)Load Impedance: min. 200ΩMax. Output Level: +26 dBu (bal. load), +21 dBu (unbal. load)
|
| Bias and Erase Frequency
|
150 kHz
|
| Magnetic Flux Level
|
MX-55N = 185/250/370 nWb/m (switchable)MX-55D = 250/320/510 nWb/m (switchable)
|
| Frequency Response(Rec/Rep. 0 dB = 250 nWb/m)
|
38.1 cm/s = 30 Hz to 20 kHz ±2 dB (0 dB)19.05 cm/s = 20 Hz to 18 kHz ±2 dB (-10 dB)9.5 cm/s = 20 Hz to 10 kHz ±2dB (-20 dB)
|
| Frequency Response(Sel-Rep)
|
38.1 cm/s = 30 Hz to 12 kHz ±3 dB19.05 cm/s = 20 Hz to 5 kHz ±3 dB9.5 cm/s = 20 Hz to 2.5 kHz ±3 dB
|
| Distortion (38.1 cm/s, 1 kHz, 250 nWb/m)
|
Less than 0.3%
|
| Crosstalk
|
MX-55N = min. 55 dBMX-55D = min. 50 dB
|
| Depth of Erasure(38.1 cm/s, 1 kHz, 1040 nWb/m)
|
MX-55N = min. 75 dBMX-55D = min. 70 dB
|
| Rec/Rep Signal-to-Noise Ratio(30 Hz to 18 kHz BPF, UNWTD)
|
MX-55N NAB 38.1 cm/s, 1040 nWb/m = 69 dBMX-55N NAB 19.05 cm/s, 1040 nWb/m = 71 dBMX-55N NAB 9.5 cm/s, 740 nWb/m = 64 dBMX-55N IEC 38.1 cm/s, 1040 nWb/m = 71 dBMX-55N IEC 19.05 cm/s, 1040 nWb/m = 68 dBMX-55N IEC 9.5 cm/s, 740 nWb/m = 64 dBMX-55D IEC 38.1 cm/s, 1040 nWb/m = 72 dBMX-55D IEC 19.05 cm/s, 1040 nWb/m = 69 dBMX-55D IEC 9.5 cm/s, 740 nWb/m = 65 dB
|
| Test Signal Oscillator Frequency
|
100 Hz, 1 kHz, 10 kHz Sine Wave, switchable
|
|
|
|
Miscellaneous
| Power Requirement
|
100/110/117/200/220/240 VAC, ±10%, single phase 50/60 Hz
|
| Power Consumption
|
150 VA
|
| Operating Environment
|
Temperature: 5 to 45°C, Relative Humidity: 20 to 80%
|
| Storage Environment
|
Temperature: -20 to 45°C, Relative Humidity: 10 to 80%
|
| Weight
|
30 kg
|
| Dimensions (W x D x H)
|
440 x 222 x 488 mm
|
| Standard Accessories
|
NAB Reel Adapter10.5" Empty Reel (MX-55N only)DIN 12" Empty Reel (MX-55D only)Power CordFuse 1 A x 2Fuse 2 A x 4Fuse 5 A x 1Fuse 5 A (slow blow) x 1Lubrication Oil (PZ9E003)Case FootOperaiton Manual
|
| Optional Accessories
|
CB-127-S Remote ControllerZA-81G-S Stand (with Reel Spacer. Tilt Adjustable)ZA-81B-T Stand (without Reel Spacer)ZA-81D-S Reel Spacer (for ZA-81B-T)ZA-5CG Rack Mount BracketSB-12S ScissorsZA-5CU Fader Control KitPB-1AXAS VEM (Voice Edit Mode) PCBZA-5CW Proximity Switch KitZA-5CX Multi Purpose Phone Jack KitZA-5CL Input TransformerZA-5CM Output Transformer
|
|
|
|